welding-start

Welding Inverter Startup Circuit

Welding Inverter Startup Circuit The input line voltage is rectified and the DC voltage applied to the input filter capacitors. The two input relais and special electronic circuits are used. The present circuit contains precharging circuitry for the safe charging of the input filter capacitors. Once the capacitors are precharged, the input relais are energized,…

Details
on-off-circuits-with-2-relays

On-Off switch using 2 relays – Four versions

On-Off switch using 2 relays – Four versions The load wired to output of such device is connected and disconnected by each momentarily pressing on a pushbutton. The arrangement haves a toggle flip-flop function, or toggle bistable. The three versions are presented, based on the momentary pushbutton respectively single normally-open, SPDT and DPDT type. If…

Details
onof3sym

On-Off switch using 3 relays – Fifteen versions

On-Off switch using 3 relays – Fifteen versions ! Since the electrical standards adopted by various nations may vary, the graphical schematic/wiring diagram simbols can also vary (example: DIN, NEMA, IEC, EEMAC, CENELEC). This article uses International/British graphical simbols. For unambiguity, the used simbols are described in the following table: A relay control system is…

Details